Sony KF-42WE620 - Manual (Page 34)

Installing and Connecting the LCD Projection TV
34
KF-42/50WE620
2-108-981-13(1)
Connecting a VCR and Cable Box
Use this hookup if:
❑ Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
❑ You want to enjoy the Twin View feature.
With this setup you can:
❑ Use the LCD projection TV remote control to change channels on your
cable box when the signal is scrambled. To program your Sony remote
control to operate your cable box, see “Programming the Remote
Control” on page 77.
❑ Use the LCD projection TV’s remote control to change channels on
your LCD projection TV when the signal is not scrambled. Your LCD
projection TV’s tuner provides a better signal than the cable box.
❑ Use the Twin View feature. (When all channels are routed through your
cable box, only one signal is sent to the LCD projection TV, so you
cannot use the Twin View feature.)
Disconnect all power sources before making any connections.
1
Connect the coaxial cable from your cable service to the LCD projection
TV’s VHF/UHF jack.
2
Using a coaxial cable, connect the LCD projection TV’s TO
CONVERTER jack to the cable box’s IN jack. The LCD projection
TV’s internal converter allows you to switch between unscrambled
signals coming straight into the LCD projection TV and scrambled
signals coming in through the cable box, eliminating the need for an
external splitter.
3
Using a coaxial cable, connect the cable box’s OUT jack to the VCR’s
IN jack.
4
Using A/V and S VIDEO cables, connect the VCR’s AUDIO/VIDEO
and S VIDEO OUT jacks to the LCD projection TV’s AUDIO/VIDEO
and S VIDEO IN jacks.
5
Using a coaxial cable, connect the VCR’s OUT jack to the LCD
projection TV’s AUX jack.
✍
To view scrambled channels, set your LCD projection TV to AUX 2 - 6
(depending on your cable box output). Change channels using your
cable box.