Sun Microsystems Netra T1 AC200 - Manual (Page 4)

1. Power off your system and open the system unit.
Remove the top cover by following the procedure described in the
Netra T1 AC200 and DC200 Server User’s Guide (part number 806-
5978-10). Make sure you disconnect all power cables and wear an
antistatic wrist strap.
2. Locate the wrist strap, and attach its adhesive copper strip to the
metal casing of the power supply. Wrap the other end twice
around your wrist with the adhesive side against your skin.
3. Locate the DIMM slots on the motherboard (see Figure 1-2).
4. Unpack the DIMM, holding it only by the edges.
Figure 1-1 Unpacking the DIMMs