Sony STORSTATION LIB-D81 - Manual (Page 49)

49
Appendix
71
Detected calibration error
(notch readings abnormal). [L ] and [7 1] appear
alternately on the message
display.
Yes
72
Detected calibration error.
(Upon calibration of the lower
edge of the drive rim, it was
detected that it needed to be
calibrated above the upper
limit.) [L ] and [7 2] appear
alternately on the message
display.
Yes
78
Because cartridge pickup
failed, when performing
recovery it is impossible to do
so because there are no
available slots. [L ] and [7 8] appear
alternately on the message
display.
Yes
7A
The door lock sensor does not
close when attempting to lock
the front door. [L ] and [7 A] appear
alternately on the message
display.
Yes
7B
The door lock sensor does not
lock when attempting to lock
the front door. [L ] and [7 B] appear
alternately on the message
display.
Yes
7C
The door lock sensor does not
unlock when attempting to
open the front door. [L ] and [7 C] appear
alternately on the message
display.
Yes
80
Detected a GAP when the
elevator is in movement. [L ] and [8 0] appear
alternately on the message
display.
Yes
81
Cannot detect the normal
number of notches when the
elevator is in movement. [L ] and [8 1] appear
alternately on the message
display.
Yes
82
The pulse of the last notch is
determined to be ±xx mm out
of position when the elevator
is in movement. [L ] and [8 2] appear
alternately on the message
display.
Yes
83
The pass sensor fails to
change even if space between
notches is 1.5 times wider
when the elevator is in
movement. [L ] and [8 3] appear
alternately on the message
display.
Yes
88
Cannot detect the lower edge
of the elevator during the
initialization MOVE. [L ] and [8 8] appear
alternately on the message
display.
Yes
89
Cannot detect the lower edge
of the elevator during the
calibration MOVE (in Type
Drive). [L ] and [8 9] appear
alternately on the message
display.
Yes
8A
Cannot detect the notch edge
during the initialization MOVE. [L ] and [8 A] appear
alternately on the message
display.
Yes
90
Detected a GAP at the end of
the picker movement. [L ] and [9 0] appear
alternately on the message
display. Yes
91
Cannot detect the RVS sensor
during picker movement. [L ] and [9 1] appear
alternately on the message
display.
Yes
92
Cannot detect the FWD
sensor during picker
movement. [L ] and [9 2] appear
alternately on the message
display.
Yes
Error code Description Display Logged