Sanyo KHS0951 - Manual (Page 15)

Operation with the Remote Control Unit (continued)
NOTE • This appliance has a built-in 3-minute time delay circuit to ensure
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the unit
will restart automatically after five minutes.
3. Adjusting the
Fan Speed
A. Automatic Simply set the FAN SPEED selector button to the position.
A microcomputer in the air conditioner automatically controls the fan speed
when the
mode is selected. When the air conditioner starts operating,
the difference between the room temperature and the set temperature is
detected by the microcomputer which then automatically switches the fan
speed to the most suitable level.
Cooling and DRY mode:
When difference between
room temperature and set
temperature is
FAN SPEED
4
°
F and over High
Between 4
°
F and 2
°
F Medium
Below 2
°
F Low
Heating mode:
When difference between
room temperature and set
temperature is
FAN SPEED
4
°
F and over High
Below 4
°
F Medium
, , or ]
15
OI-351-15EG
oi202000
B. Manual If you want to adjust fan speed manually during operation, just set the FAN
SPEED selector as desired. [
NOTE The above mentioned data make reference to the conditioner operating
when the sensor on the remote control unit is ON. (Refer to temperature
sensor selector). If the sensor on the indoor unit is being used then
actual operation will slightly differ from that described in the above
tables. ( Sign shown on the remote control unit display.)