Sony BRC-Z330 - Manual (Page 47)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
47
9
Connect the cables to the connectors on the rear of
the camera.
Note
Take the proper steps to ensure that the load of the
cables connected does not cause problems.
10
The SONY and/or HD nameplates can be turned
upside down, if necessary.
To remove the camera
1
Remove the three screws used to attach the camera
in step 8 of “Installation on a ceiling (example).”
2
Turn the camera with the bracket counterclockwise
to remove.
Installation on a shelf, etc. in a high
position (example)
1
Remove the four screws on the bottom of the
camera to remove the four feet.
2
Attach the ceiling bracket (A) to the bottom of the
camera using the supplied four screws (3M3 × 8).
Position the a hole for screwing on the ceiling
bracket (A) to the front of the camera as illustrated,
align the screw holes on the ceiling bracket with
those on the bottom of the camera, then attach the
bracket to the camera.
Ceiling
3M3 × 8 (supplied)
Ceiling bracket (A)
Front of camera