Servis-Rhino FM84 - Manual (Page 93)

In addition to the standard Limited Warranty, Rhino provides one year (12
months), (6 months for Commercial/Industrial Users) Limited Warranty on the
Driveline components provided that these components have been properly main-
tained and lubricated that and have not been subjected to abused or mis-use
Keep children away from danger all day, every day...
Equip tractors with rollover protection (ROPS) and keep all machinery
guards in place...
Please work, drive, play and live each day with care and concern
for your safety and that of your family and fellow citizens.
In addition to the standard Limited Warranty shown on the preceding page, Servis-Rhino provides A
ONE YEAR LIMITED WARRANTY on GEARBOX components* provided that these components have
been properly maintained and lubricated and have not been subjected to abuse or mis-use
*One year for Seals (After on year, (six months for Industrial/Commercial use) seals are consid-
ered to be REPLACEMENT PARTS and replacement is the users' responsibility.)
* Users' Gearboxes may be rebuilt by Servis-Rhino or replaced by new or rebuilt Gearboxes at
the option of Servis-Rhino.
NOTE: "Failure to Maintain" also includes failure to adjust Slip Clutches correctly to provide
proper protection for Driveline and Gearbox components.
NOTE: "Failure to Maintain" specifically includes running Gearboxes without proper lubrication
and "burning up" the components.
TO THE OWNER/OPERATOR/DEALER
To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions
and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can
easily find the information you need.
The OCCUPATIONAL SAFETY AND HEALTH ACT (1928.51 Subpart C) makes these minimum safety
requirements of tractor operators:
REQUIRED OF THE OWNER:
1. Provide a Roll-Over-Protective Structure that meets the requirements of this Standard; and
2. Provide Seatbelts that meet the requirements of this paragraph of this Standard and SAE J4C; and
3. Ensure that each employee uses such Seatbelt while the tractor is moving; and
4. Ensure that each employee tightens the Seatbelt sufficiently to confine the employee to the protected
area provided by the ROPS.
REQUIRED OF THE OPERATOR
1. Securely fasten seatbelt if the tractor has a ROPS.
2. Where possible, avoid operating the tractor near ditches, embankments, and holes.
3. Reduce speed when turning, crossing slopes, and on rough, slick, or muddy surfaces.
4. Stay off slopes too steep for safe operation.
5. Watch where you are going - especially at row ends, on roads, and around trees.
6. Do not permit others to ride.
7. Operate the tractor smoothly - no jerky turns, starts, or stops.
8. Hitch only to the drawbar and hitch points recommended by the tractor manufacturer.
9. When the tractor is stopped, set brakes securely and use park lock, if available.