beautypg.com

Warning, Long term storage (over 30 days), Danger – Shindaiwa DH212 User Manual

Page 26: Torage

background image

26

ENGLISH

s

toraGe

WARNING

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear

of flammable debris during transportation or when storing, otherwise serious personal injury may result.

Long Term Storage (over 30 days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte-

nance which includes the following:

Store unit in a dry, dust free place, out of the reach of children.

WARNING

Hedge Trimmer blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades

whenever possible, and always wear gloves to protect hands.

DANGER

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark, otherwise serious per-

sonal injury may result.

1.

Place the stop switch in the “OFF” position.

Remove accumulation of grease, oil, dirt and debris from

exterior of unit.

Perform all periodic lubrication and services that are

required.

Apply clean oil to the entire length of the blade. Be

certain the blade bolts are lubricated.

Install blade cover on blades.

Tighten all the screws and nuts.

drain the fuel tank completely and pull the recoil starter

handle several times to remove fuel from the carburetor.

2.

3.

4.

5.

6.

7.

8.

Remove the spark plug and pour 7cc (1/4 oz.) of fresh,

clean, two-stroke engine oil into the cylinder through the

spark plug hole.

A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2-3 times to distribute

the oil inside the engine.
C. Observe the piston location through the spark

plug hole. Pull the recoil handle slowly until the

piston reaches the top of its travel and leave it there.

Install the spark plug (do not connect ignition cable).

9.

10.

IMPORTANT

Always store and transport hedge trimmers in a stable, horizontal position. Support gear case and cutting blades to

prevent excessive flexing, which may cause damage to these components. Always install blade cover when transport-

ing or storing unit.

This manual is related to the following products: