Samsung DLP TV SP46L6HX - Manual (Page 8)

English - 8
➢
M
To view television channels correctly, a signal must be received by
the set from one of the following sources:
◆ An outdoor aerial
◆ A cable television network
◆ A satellite network
1 In the first three cases, connect the aerial or network input cable to
the
ANT IN jack on the rear of the television.
2 If you are using an indoor aerial, you may need to turn it when
tuning your television until you obtain a picture that is both sharp
and clear.
For further details, refer to:
◆ “Storing Channels Automatically” on page 15.
◆ “Storing Channels Manually” on page 16.
Connecting to an Aerial or Cable Television Network
Rear of the TV
Cable Television
Network
or
Connecting a Satellite Receiver or Decoder
In order to watch television programmes broadcast via
a satellite network, you must connect a satellite receiver
to the rear of TV. Also, in order to descramble a coded
transmission signal, you must connect a decoder
to the rear of TV.
◆ Using a RCA cable
Connect the receiver (or decoder) RCA cable to one of the
RCA connectors on the rear of the television.
◆ Using a coaxial cable
Connect a coaxial cable to the:
- Receiver (or Decoder) output socket.
- Television aerial input socket.
➢
If you wish to connect both a satellite receiver (or decoder)
and a VCR, you should connect the:
◆ Receiver (or Decoder) to the VCR
◆ VCR to the television
Otherwise, connect the receiver (or decoder) directly to
the television.
Rear of the TV
Satellite Receiver/
Decoder
BP68-00478E-00Eng_0826 8/26/05 6:04 PM Page 8