SVAT Electronics CLEARVU2 - Manual (Page 26)

SVAT ELECTRONICS
now you can see
CLEARVU2 23
DVR not recording
1. Make sure recording is enabled in each camera’s setting. Go to
>Camera Setup>Camera Setting and enable recording for each camera if it
has been disabled.
2. Make sure recording is enabled and set to the correct recording setting in
scheduled recording. Go to >Record Setup>Record Mode. If a line
(-) is over any hour of the day, that means recording is disabled for that time
period. Press ►/4 to enable recording for that hour. Also make sure you
press REC when you return to Monitoring Mode, or your scheduled recording
will not take effect.
3. Your disk may be full. By default the DVR should start writing over your
recorded files, but this option may be disabled. Go to Menu>Hard Drive
Setup>Disk Full. Set it to OVERWRITE.
4. Make sure your DVR is in Monitoring Mode, and not at a menu screen or in
Playback Mode.
No playback 1. There is a delay while the DVR searches for your recorded files. Wait a few
moments and your files should appear.
2. Make sure you are not in Recording Mode. Pressing PLAY during recording
will have no effect. Press STOP first.
3. If you have just formatted the hard drive or your drive is otherwise empty,
there will be no files to play back.
During playback, I can’t switch to
different camera views.
To switch between cameras during playback, you must have recorded in
EACH mode. Change this setting using >Record Setup>Record
Type.
DVR PLAYER TROUBLESHOOTING
No display on television 1. Make sure all RCA and power cables are plugged in securely and in their
proper places.
2. Make sure your television is on the correct channel (input mode).