1 installation overview, 2 installation procedure of windows 98 – Samsung SWL-2210M User Manual
Page 14

14
3. MagicLAN Installation For
Windows 98/ME/NT4.0/2000/XP
We will explain the installation method for
SWL-2210M/P (MiniPCI/PCI Card)
.
3.1 Installation Overview
Here are some steps you will perform in establishing your wireless network connection:
1. Install the Access Point at first. AP is needed in case of Infrastructure network
mode.
2. You should install the Wireless LAN Card (
SWL-2210M/P
).
3. Install the software using the Installation CD.
4. Install the network protocol(s) required to communicate on your network. Most
likely you will need the TCP/IP protocol.
3.2 Installation Procedure of Windows 98
Please follow the following steps one by one to install the
MiniPCI/PCI
card successfully.
< Method 1 - Inserting card first >
1. Insert the MiniPCI/PCI Card into the slot of your computer.
2. Power on your computer and allow Windows 98 to load fully.
3. “Add New Hardware Wizard” appeared and the system looks for “PCI
Network Controller”. Press ‘NEXT’ button and check if “Search for the best
driver for your device(recommended)” is slected and then press ‘NEXT’
button . Insert the MagicLAN Installation CD into the CD-ROM drive.
4. Mark the “Specify a location” tap and type “E:\Drivers” right below in this
tap(Where E is the CD-drive of your PC) and then press ‘NEXT’.