Samsung RS267TD** - Manual (Page 14)

14_ setting up
setting up your side-by-side refrigerator
SETTING UP THE REFRIGERATOR(CONT’D)
If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.
Tools you will need
Removing the Front Leg Cover
First, open both the freezer and refrigerator doors, and then take off the front leg cover by turning the
three screws counter-clockwise.
Separating the Water Supply Line from the Refrigerator
1. Remove two water lines(gray one is for ice and the other one is for water)by pressing the coupler
1 and pulling the water line 2 away.
Reattaching the Water Supply Line
1. The Water Line must be fully inserted to the
marked line to prevent water leakage from
the dispenser.
2. Insert the 2 clips in the install pack
and check that each clip holds the
line firmly. These clips are for door
re-installation only.
The water line must be fully inserted to the marked line to prevent water leakage from the
dispenser.
FRONT LEG COVER
SCREW
1
2
Make sure the color of the
water lines match.
Line Line
Coupler Coupler
clip A
(¼”)
(6.35mm) clip A
(¼”)
(6.35mm)
Coupler Coupler
Philips Screwdriver Flat-blade Screwdriver 10mm Socket Wrench