Sharp FO-3150 - Manual (Page 74)

Optional A.M. Mode Settings
72
Quiet Detect Start Time
This setting can be used to delay the start of the Quiet Detect Time function.
For example, if you want to insert a pause at the beginning of your answering
machine’s outgoing message to ensure clear detection of fax signals, you can
use this setting to delay the start of silence detection so that the pause will not
cause the fax to take over the line.
Quiet Detect Start Timing has been set to five seconds at the factory. You can
change this setting by entering a 2-digit number equal to the desired number
of seconds of the delay, or turn the function off by enttering 00. As general
guide, the delay time should be slightly longer than the pause before the
outgoing message.
1
Press once and 3 times.
2
Press once and 8 times
.
3
Press once.
4
Enter a 2-digit number (from 01 to 15)
for the number of seconds of the delay,
or enter 00 to turn off the function.
Example: 3 seconds
5
Press to return to the date and time display.
FUNCTION
0 3
STOP
Display:
OPTION SETTING
QUIET START
ENTER (00-15) 05
The display briefly shows
your selection, then:
ON TAD FAILURE