Sharp FO-3150 - Manual (Page 104)

Messages and Signals
102
Messages and Signals
Display messages
ADD PAPER & /
PRESS START KEY
(alternating messages) Check the printing paper. If the tray is empty, add
paper and then press the START key. If there is paper
in the tray, make sure it is inserted correctly (take out
the stack, align the edges evenly, and then reinsert it
in the tray) and then press the START key.
COVER OPEN The print compartment cover is open. Close it.
DIAL WAITING Dialing is not possible because the fax machine is
sending or receiving a fax, the handset is being used,
or an extension phone is being used.
DOCUMENT JAMMED The original document is jammed. See the following
section,
Clearing Paper Jams. Document jams will
occur if you load more than 20 pages at once or load
documents that are too thick (see page 31). The
document may also jam if the receiving machine
doesn’t respond properly when you attempt to send a
fax.
DRUM LIFE OVER This appears when the drum cartridge needs
replacement.
FAX RX IN MEMORY A fax has been received in memory because the
toner cartridge needs replacement, you have run out
of printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FUNCTION MODE The FUNCTION key has been pressed.
GROUP SPACE FULL This appears if you attempt to program a Group Key
when all Group Keys have already been
programmed.
HEATER HIGH/
HEATER LOW/
HEATER ERROR If one of these messages appears, unplug the power
cord and then plug it back in. If the message still
appears, call for service.