Sony CCU-D50P - Manual (Page 26)

26
Changing Settings
When the MENU button on the front panel is lit, a
menu appears on the monitor connected to the
MONITOR OUT connector, allowing you to change
the settings of the system including this unit.
To operate the menu
Proceed as follows.
1
Press the MENU button on the front panel, turning
it on.
A menu appears on the monitor connected to the
MONITOR OUT connector.
2
Press the SELECT up or down button to select a
page, and then press the ENTER button.
3
Press the SELECT up or down button to select a
menu item, and then press the ENTER button.
4
Press the SELECT up or down button to select a
setting for the item, and then press the ENTER
button.
Press the CANCEL button to return to the previous
state.
Page1: Setup Menu page
This page controls camera/camcorder and CCU
functions.
1
4
3
2
5
7
6
8
*Setup Menu*
MATRIX
IRIS
EVS
TITLE
CLOCK
RCP RATE
TLCS
SKIN DTL
: STANDARD
: STANDARD
: OFF
: OFF
: OFF
: 38400
: OFF
: OFF
a) This can also be set for the DXC-D35/D35WS series, but
the setting is ignored.
b) When the CCU command mode (see “qh System setting
switches” on page 18) is set to on (TX7 mode), the
selections for this item are CAM, BARS, and OFF.
When the CCU command mode is set to off (M5A
mode), the selections for this item are ON and OFF. For
details, refer to the operation manual of the camera/
camcorder.
c) Always select 38400 when a RCP-TX7 (not available in
EU countries) is connected. Selecting anything other than
38400 will prevent a connection from being made.
d) This item does not appear when the CCU command mode
is set to off (M5A mode).
No.
1
2
3
4
5
Description
CA SDI PLL status
200 m (656 feet) cable
compensation setting
Return signal mode
SKIN-GATE MIX function setting
Output mode setting
Value
OK, NG
ON, OFF
COLOR, B/W
ON, OFF
Y/C, R/G/B,
Y/B–Y/R–Y
No.
1
2
3
4
5
6
7
8
Function
Switch color matrix
function.
a)
Switch AUTO IRIS
mode.
Turn EVS on and off.
Turn TITLE display on
and off.
Turn time display on
and off.
b)
Set communications
speed for REMOTE
connector on the rear
panel.
c)
Turn TLCS function on
and off.
d)
Turn skin detail
function on and off.
d)
Settings
STANDARD,
COLORFUL,
FL LIGHT
STANDARD,
SPOT 1.,
BACK 1.
ON, OFF
ON, OFF
CAM,
BARS, OFF
38400, 9600
ON, OFF
ON, OFF
Factory
default setting
STANDARD
STANDARD
OFF
OFF
OFF
38400
OFF
OFF