Sharp XG-P20XU - Manual (Page 33)

E-32
Operation Buttons
Using GyroRemote
Preparation
1
Switch on the projector power source. The projector
image will appear on the screen.
2
Pull out the projector antenna.
• The control range will not be optimized if you do not pull
out the antenna. Always use with the antenna fully
extended.
• The control range under actual operating conditions may
be less than optimum depending on where the projector
is placed and the radio signal environment.
3
Press POWER on the GyroRemote, located on the
front, inside the upper cover.
• The GYRO RF indicator on the projector flashes green
whenever it receives a radio signal from the GyroRemote.
Operating the screen pointer
1
Press POINTER on the GyroRemote.
As the POINTER is being pushed, a pointer on the
screen will display. If you release your finger from
the
POINTER it will disappear from the screen.
2
Hold the GyroRemote and move it around freely in
the air. The pointer on the screen moves precisely
in concert with the movement of your GyroRemote
in hand.
Menu Adjustments
1
Open the upper cover on the front of the
GyroRemote.
2
Press MENU.
3
Press GYRO ACTIVE on the back of the
GyroRemote, and select your desired category by
moving the unit left or right.
4
Then select the desired item by moving the unit up
or down.
5
Move the unit left or right, or press
؁/؀ to adjust
item values.
6
Press MENU.
The menu display disappears.
• Double click on GYRO ACTIVE, the LED will light and you can
operate GyroRemote just like pressing the button continuously. To
cancel this mode, press GYRO ACTIVE once.
• If you release GYRO ACTIVE located on the back of the unit, you
will not be able to control operations no matter how you wave your
hand in the air.
Antenna