SeaLand 1 2500 Series - Manual (Page 6)

6
INSTALLATION (cont’d)
ELECTRICAL INSTALLATION
The 12V DC connection to the toilet electronics
is shown in the photo.
Connect by correct polarity:
RED + WHITE –
The connection wire must be 14-gauge stranded
copper wire, and must be protected by a 5-amp
fuse (see wiring diagram).
Electrical installation
must be performed by
qualified personnel only!
POSITIVE
+
NEGATIVE
–
Connecting Status Panel to
Docking Platform Circuit Board
The status panel’s 4-stranded cable connects to
the circuit board (shown below right).
.
Circuit board
location
WARNING: Power wires must be
connected as shown. Incorrect wiring
will damage circuit board.
WHITE RED
WARNING: Power wires must be
connected as shown. Unit will not
operate until power wires are properly
connected.