Speco Technologies D8RS - Manual (Page 31)

31
4-5. Setup – DISPLAY Mode
In the SETUP menu, select the DISPLAY tab. Then, the DISPLAY menu is displayed as pictured below.
Navigate through the menu items using the mouse or the control button on the remote control and change
the value of the menu item. To return to the previous setup menu screen, press the ESC button.
Figure 4.5.1. DISPLAY Setup Screen
Table 4.5.1. Menu Items in DISPLAY Setup Screen
Item Description
OSD Enable/disable on-screen-display.
OSD CONTRAST Set the visibility level of the On Screen Display (OSD) (0~100)
SEQUENCE Enable/disable sequential display of video in full screen mode.
SEQUENCE
DWELL TIME
Set the dwell time of each,
single channel display in sequential display mode (3~60seconds)
SITE Select a channel to apply the name and covert settings change using the
mouse or control button on the remote control.
Select a channel to apply the following settings using the mouse.
NAME Set the channel name. Press the right square button and set the channel
name and select OK using the mouse.
The name can be made up to 36 characters.
COVERT Enable/disable display of the specified video channel in live display.