Sharp DX-B450P - Manual (Page 38)

3-12 User’s Guide
Operator Panel Menus
Operator Panel
Binary PS On/Off On When On, the feature allows all binary codes
to be processed by the PostScript interpreter.
When Off, special binary control codes may
be intercepted per the Format item setting.
Factory Defaults Yes
No No Resets the menu to factory network defaults.
Connection Speed Auto-Sense
100Mbit Half
100Mbit Full
10Mbit Half
10Mbit Full Auto-Sense Configures the Ethernet connection speed
(10 or 100 Mbits/second) and
communication mode (full or half duplex).
The “Auto Sense” setting attempts to
auto-negotiate this connection with the
networking hardware, usually a switch.
When a setting other than “Auto Sense”
must be used, the following should be
considered: If connected to network switch,
the “100Mbit/Full” setting can be used. If
connected to a hub, use the “100Mbit/Half”
setting.
Bidirectional On/Off On When this setting is “on”, the printer may
receive and send information over the
network interface. When this setting is “off”,
the printer will only receive information
over the network interface. This applies
primarily when using printing over a “Port
9100” connection. This setting normally
should be left at its default setting, should
only be turned “off” under special
circumstances
.
Wait timeout 0000-9999 0270 (In Seconds): Specifies the amount of time
the printer will allow a network connection
to remain open without transferring data
before the printer terminates the connection.
SNMP On/Off On/Off On
HTTP Port 00000-99999 00080 Specifies the TCP port number to use for
HTTP connection to the printers embedded
web server.
IP Filtering Disabled
Enabled Disabled (available via web server only): Allows an
administrator to control access to printing
and access to the embedded web server on
the basis of IP addresses. This is a security
feature.
USB Setup This item allows you to set up the USB
interface.
Interpreter Auto Switch
PCL
PostScript 3 Auto Switch
Menu Item Value Default Description