Sharp DX-B450P User Manual
Page 37
User’s Guide
3-11
Operator Panel Menus
Operator Panel
Network Address
address>
NA
Displays MAC address of network interface.
IP Address
data entry
000.000.000.000
IP Address. If DHCP is enabled, this is
read-only. Otherwise, this can be changed by
the address can be set manually here
Subnet Mask
data entry
000.000.000.000
Default Gateway
data entry
000.000.000.000
LPD Banner
On/Off
Off
If ON, prints a special “banner page” before
each LPR print job.
DHCP
On/Off
On
IPv6
On/Off
Off
Delay Out Close
On/Off
Off
When ON, the printer will wait until the job
is completely printed and delivered to the
output tray before terminating the
connection, allowing all reverse-channel
data to be sent back to the host. This will
cause a reduction in printer throughput.
When OFF, reverse-channel data generated
after the job interpretation is discarded. No
reduction in printer throughput occurs.
mDNS
On/Off
On
Enabled multicast-DNS protocol. mDNS is
the underlying protocol for “Bonjour”.
Local Link
read-only
000.000.000.000
Auto-negotiated “local link” internet address
(used primarily by Bonjour protocol)
Multi-Session
On/Off
Off
When On, allows the printer to have
multiple network print sessions open at a
time. When Off, only 1 session can be
opened at a time. Some server environments
may benefit from a setting of Off.
EtherTalk
On/Off
On
Netware Setup
This submenu allows you to set up the
Netware interface.
Netware
On/Off
Off
Netware Frame
Auto-Sense,
802.3,
Ethernet II,
802.2 SNAP,
802.2
Auto-Sense
Netware Mode
NPRINTER
PSERVER
PSERVER
Menu Item
Value
Default
Description