Silvercrest KH 2029 User Manual

Page 14

- 12 -

Setting the MW band

Since the radio transmitter systems differ from one
country to another, you should make the appro-
priate setting via the reception range setting:

•

Press the

MODE

button six times and then use the

DOWN

button to select the corresponding

reception range as per the following table:

Region Channel

spacing Band

range

America 10 kHz

520–1710 kHz

Europe 9 kHz

522–1656 kHz

Fine tuning

If a station can not be found precisely the fine
tuning can be use to improve reception.

•

During the channel search press the

FINE

button, the screen shows FINE.

•

The

and

DOWN

buttons can now be used to set

the desired frequency in half frequency steps.

•

By pressing the

FINE

again you leave the fine

tuning function again.

This function is not available for the LW frequency
range.

Aerial

The rotatable telescopic aerial on the radio can be
used for the FM and SW bands.

•

Pull the aerial out fully and arrange it for
optimum reception.

The

SW SEN.

switch on the left side of the device

can be used to improve the reception quality for
the SW band. Select LX for strong stations and RX
to improve reception for weak stations.

The telescopic aerial does not work in the MW and
LW bands. In these bands, the radio uses its built-in
ferrite aerial.

•

Align the radio for best reception.

Memory functions

Save station

The world receiver can save 400 stations in each
frequency range.

To store a station, proceed as follows:

•

Set the frequency range with the frequency
selection switch and then the station that you
want to save (see above).

•

Press the

MEM

button. The screen shows the

PAGE memory page and MEM flashes.

•

Within 10 seconds press the

PAGE

button

(the PAGE message flashes), and then select
a memory page (from 00–39) using the

DOWN

button.

•

Within 10 seconds use the

M.0/5

–

M.4/9

buttons

to select a memory space to store the station. For -
example, press the

M.0/5

button once for memory

space 0 and again for memory space 5. The oc-
cupancy is shown on the screen.

•

Press

MEM

again to save the station. The PAGE

and MEM messages are shown on a perma-
nent basis.

Note:

If the world receiver is connected to the mains
adapter and no batteries have been inserted,
the station memories are lost when the adapter
plug is pulled from the socket.

IB_KH2029_AR23586_LB3C 18.08.2008 15:56 Uhr Seite 12