Silvercrest KH 2029 - Manual (Page 13)

- 11 -
When the set time has been counted down, an
alarm sound plays for one minute becoming
gradually higher in tone and louder.
• Press the MEMORY SCAN button to pause the
countdown and leave countdown mode.
Radio operation
Switching on/volume control
• Press the POWER ON button to switch the radio
on. ON will appear briefly on the screen,
followed by the current frequency and band
selection.
• Press the VOL.+/AL–1 or VOL.–/AL–2 button to
control the volume:
Button
VOL.+/AL–1 : louder.
Button VOL.–/AL–2 : quieter;
The volume is shown on the bar indicator to the
bottom right of the screen.
Switch on bass amplifier
• When the radio is switched on, press the BASS
button to switch on the bass amplifier. The
screen will flash BASS.
• In order to switch the bass amplifier off again,
press
BASS one more time. The BASS message
disappears.
Turning off
• Switch the radio off by pressing the POWER
button. OFF is shown briefly on the screen
and the time is displayed again.
Sleep function
You can activate the sleep function via the SNOOZE
button. You can set a time of up to 90 minutes in ten-
minute steps, after which the radio will automatically
turn itself off. To do so, first switch the radio off.
• Press the SNOOZE button. The symbol for the
sleep function and 90 (for 90 minutes)
will appear.
• Press the SNOOZE button repeatedly until 90
is displayed to count down the sleep time
in 10 minute steps.
• Either select a sleep time (the sleep symbol
remains on the screen) or press SNOOZE
again until OFF appears on the screen.
The sleep function is now switched off.
Setting the station
• Select the required frequency band (FM, MW,
LW or SW), using the frequency select button.
The corresponding abbreviation will appear on the
screen.
• The UP and DOWN buttons can now be used
to set the desired frequency.
• If you keep UP or DOWN pressed for about three
seconds, the automatic station search will start.
• The search stops as soon as a station with
sufficient signal strength is found.
In the FM frequency range the RDS symbol
is displayed if an RDS station is received.
IB_KH2029_AR23586_LB3C 18.08.2008 15:56 Uhr Seite 11