Sunwave Tech. SRC-3820 User Manual

Page 51

Troubleshooting Tables

Problem

Solution

An “ERROR”

message is

displayed while
operating

1. There is no code in the key or button.

“REC” key can not

be used

1. For safety issue, the SRC-3820 requests

users to tap “REC” key over 2 seconds

at least.

The code can not

be learned
successfully

1. Make sure the SRC-3820 and original

remote renew batteries.

2. Make sure you press each hard

button of original remote at least over

2 seconds.

3. Make sure the original remote would

aim at learning eye of SRC-3820

straightly.

4. Keep 2~4 inches (5~10 cm) apart

between SRC-3820 and the original

remote.

5. Do not learn near an incandescent

lamp.

6. Memory capacity is full.
7. Make sure the original device is using

IR system.

A button stores

two or more
codes

1. In SRC-3820, you should store each

code to individual key by learning.

When you enter

a code number
but coming out
an “ERROR”
message

1. The code number doesn’t exist in the

code list.

2. The code number doesn’t belong

to the attribution same with your
target device.