Samsung SRS610HDSS - Manual (Page 4)

_ safety information
• In order to avoid the creation of a flammable gas-air mixture if a leak in the
refrigerating circuit occurs, the size of the room in which the appliance may be sited
depends on the amount of refrigerant used.
• Never start up an appliance showing any signs of damage. If in doubt, consult your
dealer.
• The room must be 1m 3 in size for every 8g of R600a refrigerant inside the appliance.
• The amount of refrigerant in your particular appliance is shown on the identification
plate inside the appliance.
• Please dispose of the packaging material for this product in an environmentally
friendly manner.
• Pull the power plug out of the socket before changing the interior light of the
refrigerator.
- Otherwise, there is a risk of electric shock.
seVere warning signs
• Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
• Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room
heaters or other appliance.
• Allow sufficient space to install the refrigerator on a flat surface.
- If your refrigerator is not level, the internal cooling system may not work correctly.
• Do not plug several appliances into the same multiple power board. The refrigerator
should always be plugged into its own individual electrical which has a voltage rating that
matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits,
which could cause a fire hazard from overheated wires.
• Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and
pull straight out from the outlet.
- Damage to the cord may cause a short-circuit, fire and/or electric shock.
• Make sure that the power plug is not squashed or damaged by the back of the
refrigerator.
• Do not bend the power cord excessively or place heavy articles on it.
- This constitutes a fire hazard.
• Have the power cord repaired or replaced immediately by the manufacturer or its service
agent if power cord has become frayed or damaged.
• Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• If the power cord is damaged, have it replaced immediately by the manufacturer or its
service agent.
• When moving the refrigerator, be careful not to roll over or damage the power cord.
• Do not insert the power plug with wet hands.
• Unplug the refrigerator before cleaning and making repairs.
• Do not use a wet or damp cloth when cleaning the plug.
• Remove any foreign matter or dust from the power plug pins.
- Otherwise there is a risk of fire.
• If the refrigerator is disconnected from the power supply, you should wait for at least ten
minutes before plugging it back.
• If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
• The appliance must be positioned so that the plug is accessible after installation.
safety information
WARNING
WARNING
DA99-01507A(HM-134a)-EN(0.0).ind4 4 2007.4.21 9:59:41 AM