Samsung SRS610HDSS - Manual (Page 21)

setting up _1
setting up your side-by-side
refrigerator
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether
water is running through the water tube on the
water inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
Attach the purifier lock stations.
- Hold the purifier lock stations in the appropriate
position (under the sink for example) and fix it tightly
into place where to screw.
Secure the purifier in position.
- Fix the purifier in position, as shown in the
figure on the right.
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the
figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
Secure the water line.
- Using clip ”A”, fix the water line to the wall (the back of
refrigerator).
- When the water line is secure, make sure whether the water line
is not excessively bent, pinched or squashed.
01
setting
u
P
WATER LINE
PURIFIER
WATER
OUTLET SIDE
OF PURIFIER
CLIP A
WATER LINE
TIGHTENING
BAND
PURIFIER
WATER TUBE
PURIFIER
LOCK
STATIONS
TWO PURIFIER LOCK
STATION
TWO PURIFIER LOCK
STATION
WATER LINE
INSTRUCTIONS
COMPRESSOR COVER OF
REFRIGERATOR
CONNECTION NUT
DA99-01507A(HM-134a)-EN(0.0).ind21 21 2007.4.21 10:0:1 AM