Sun Microsystems 1500 - Manual (Page 4)

12-16 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 2003
FIGURE 12-13 Smart Card Reader Location and Identification
12.3.2 Removing the Smart Card Reader
1. Power off the system, open the chassis, and remove the bezel.
Refer to:
■ “Powering Off the Workstation” on page 10-4
■ “Removing the Access Panel” on page 10-12
■ “Removing the Bezel” on page 10-14
2. Locate the smart card reader.
The smart card is installed on a smart card reader bracket that fits into the top slot of
the removable media bay. See
FIGURE 12-13 .
3. Disconnect the interface cable from the motherboard.
The cable is connected on the motherboard at SCR0 . See FIGURE 12-14 .
Smart card reader
Smart card reader
bracket Drive rails
Smart card reader
cable
Connector SCR0