Sangean RCR-8 User Manual
Page 35
34
GB
Backlight
Press the Dimmer button to adjust the display backlight settings to suit
your needs.
Separate settings are available for Active mode (while operating
the radio), Inactive mode (when listening), and Standby mode (when the
radio is off with just the clock display showing).
Language selection
This facility allows you to change the display language for the menus.
1. Press the Tuning+/- buttons until it shows “Setting”, and then press
the Select button.
2. Press the Tuning+/- buttons until it shows “Language”, and then
press the Select button.
3. Press the Tuning+/- buttons until it shows the language you would
like to select, and then press the Select button.
Software version display
The software version display is provided for your reference only.
1. Press the Tuning+/- buttons until it shows “Setting”, and then press
the Select button.
2. Press the Tuning+/- buttons until it shows “Version”, and then press
the Select button.
3. The display will show the version of the software.
4. Use the Back button to exit.
Network configuration (For RCR-7 only)
This menu enables you to configure your radio’s network settings,
scan for a connection to an alternative wireless network, or to
manually configure the network parameters. This can be useful if you
take the Internet radio to another location where there is a different
network setup.
Configuring the radio only to use a wired Ethernet connection
(For RCR-7 only)
1. Turn on the radio, and press the Tuning+/- button until the display
shows
the Select button.
2. Press the Tuning+/- buttons until it shows
Then press the Select button.
3. Press the Tuning+/- buttons until it shows
Then press the Select button.
4. Press the Tuning+/- buttons until it shows
Then press the Select button. And it will allow cause the radio to
restart and then to use only its Ethernet connection to communicate
with the network. The radio will also disable its wireless network
capabilities. This will require your radio to be physically connected
to a wired Ethernet using the RJ-45 socket on the rear panel.