Sangean RCR-8 User Manual

Page 11

Connecting your radio to your network

1. Place your radio on a surface and plug the mains lead into the Mains

input socket located on the rear of your radio (marked ) ensuring

that the plug is pushed fully into the socket.

2. Plug the other end of the mains lead into a wall socket and switch on

the wall socket.

There are 2 days of connecting your radio to the network,

wired and wireless:

When using a wired (LAN) network (For RCR-7WF only)

1. Connect the Ethernet cable into the RJ-45 socket at the back of

the radio. If a wired connection is present then the radio will use this

in preference to a wireless connection.

There are two indicator lights incorporated into the RJ-45 connector.

If you have problems with your wired connection, they may help you

to identify the possible cause of the problem.

Green ON = Link established, Flashing = Data transfer

Yellow ON = 100M bps link, OFF = 10M bps link.

2. Turn on the radio by pressing the Power button, and you can start to

operate the radio. And the display will show .