Sangean RCR-8 User Manual
Page 13
12
GB
3. There may be more than 1 wireless networks that your radio finds.
The display now shows “Select networks”. Press the Tuning+/-
buttons to search your wireless network. This is a name that is
allocated to the access point by the person who set up the
network -for example: ‘My Home Network’.
When you find your wireless network, press the Select button.
Few seconds later, the display will show
have successfully connected your radio to your network, so please
ignore the following steps.
4. If your wireless Internet access (router) has been set the password,
the display will show either ‘Enter WEP key’ or ‘Enter WPA key’.
You therefore need to enter the correct WEP or WPA key into the
radio to allow it to communicate with your network.
If you do not have the WEP or WPA key, then you should obtain it
from the person who set your network. Some Wi-Fi routers may
come with a key already set up by the supplier, in which case you
should refer to the user documentation provided with it.
5. After 3 seconds, the display goes into the key entry mode. To enter
the key, use the Tuning+/- buttons to select each character of the
key in turn, pressing the Select button after each character.
Remember, WEP keys only use the numbers 0 - 9 and letters A - F.
WPA keys are sensitive to upper and lower case characters so you
must enter them exactly.