Sony XR-C850RDS - Manual (Page 25)

25
EN
5
Press (SOUND) for two seconds.
The display goes back to the normal
playback mode.
Listening to each
programme source in its
registered surround menu
— Source Sound Memory (SSM)
You can always listen to the same source with
the same surround menu even after changing
the programme source or turning the unit off
and on again.
Changing the line output
level
You can change the line output level when you
want to adjust the level of the spectrum
analyser or when the sound is distorted.
1
Press (SHIFT), then press (2) (SET UP)
until “L.out” appears.
2
Press (4) (n) to select the desired
setting (–10 dB or –16 dB).
3
Press (SHIFT).
Additional
Information
Precautions
• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of a
two-speaker system, set the fader control to
the centre position.
•If your car is equipped with a power aerial,
note that it will extend automatically while
the tuner function is selected.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
To maintain high quality sound
If you have drink holders near your audio
equipment, be careful not to splash juice or
other soft drinks onto the car audio. Sugary
residues on this unit or cassette tapes may
contaminate the playback heads, reduce the
sound quality, or prevent sound reproduction
altogether.
Cassette cleaning kits do not remove sugar
from the tape heads.
DSP/Additional Information