Sony XR-C850RDS - Manual (Page 15)

15
EN
Changing the sound and
display settings
You can set:
•Clock (page 5)
•CT (Clock Time) (page 13)
•D. Info (Dual Information) to display the
clock and the play mode at the same time
(ON), or to display the information
alternately (OFF).
•Amber/Green to change the illumination
colour to amber or green.
•Dimmer to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
•Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit’s installed
position.
•Beep to turn on or off the beeps.
•RM (Rotary Remote) to change the operative
direction of the controls of the rotary remote.
— Select “norm” to use the rotary remote in
the factory preset position.
— Select “rev” when you mount the rotary
remote on the right side of the steering
column.
•Loud (Loudness) to enjoy bass and treble
even at low volume. The bass and treble will
be reinforced.
•LPF (Low Pass Filter)
•A. Scrl (page 16)
•Disc MEMO/TEXT name (Disc memo/CD-
TEXT name) to set the priority display item
when you connect an optional CD changer
with the CD-TEXT and disc memo function.
Note
The displayed item will differ depending on the source.
1
Press (SHIFT), then press (2) (SET UP).
2
Press (2) (SET UP) repeatedly until the
desired setting mode appears.
Each time you press (2) (SET UP), the item
changes as follows:
Clock n CT n D.Info n Amber/Green n
Dimmer n Contrast n Beep n RM n
Loud n LPF n A.Scrl n Disc MEMO/TEXT
name
Other Functions
3
Press (4) (n) to select the desired
setting (for example: “on” or “off”).
For the “Contrast” setting, pressing (4)
(n) makes the contrast higher, and
pressing (1) (N) makes the contrast lower.
4
Press (SHIFT).
When the mode setting is complete, the
normal playback mode appears.
Adjusting the frequency
of the subwoofer(s)
(XR-C850RW/C850RDS only)
To match the characteristics of the connected
subwoofer(s), you can cut out the unwanted
high and middle frequency signals entering
the subwoofer(s). By setting the cut-off
frequency, the subwoofer(s) will output only
low frequency signals so you can get a clearer
sound image.
1
Press (SOURCE) to select a source (radio,
tape, CD, or MD).
2
Press (SHIFT), then press (2) (SET UP)
repeatedly until “LPF” appears.
3
Press (4) (n) or (1) (N) repeatedly to
select desired setting.
Each time you press (4) (n) or (1) (N),
the cut-off frequency in the display changes
as follows:
LPF 120 Hz “ ” LPF 80 Hz “ ” LPF off
4
Press (SHIFT).
When the frequency setting is complete, the
display goes back to the normal playback
mode.
S e t
LPF12‚Hz SUR EQ