Sierra Wireless MP215 - Manual (Page 19)

MP215 Mobile Modem Installation, Configuration, and User’s Guide
PN0000-00 Revision 1.0 05/11/99 3-5
Figure 3-6 MP215 Revision 3 audio jack pin configuration -
looking into MP215 RJ45
NOTE Any unused pins should be left unconnected.
Mating Connector Suggestions
A suitable mating connector is: AMP P/N 5-554739-3. This connector requires a
crimping tool to mate with a flat 8-way cable.
Alternatively, several suppliers provide a pre-fabricated cable and plugs, such as
the Digi-Key IDC modular cable assemblies range.
Speaker Suggestions
The speaker output is sufficient to drive a small magnetic transducer such as the
DB Products Ltd. MDX01C Magnetic Transducer. We recommend that you
connect the speaker output to a miniature active speaker such as the Archer Mini
Amplifier Speaker, Model # 277-1008C to provide increased audio levels for use
in noisy environments.
3.5. I/O Connector
The 8-pin I/0 connector (located on the right hand side of the MP215’s front
plate) is not used by the MP215.
3.6. RF Antenna Connector
The antenna connector on the MP215 is a standard TNC female, 50 ohm
connector and should be used with a 50 ohm Cellular antenna with a bandwidth
from 824 MHz - 894 MHz and 0 dB gain. These are available from multiple
suppliers in various configurations (e.g. magnetic mount, hard-mount, direct
connection to the modem).
3 2 1 4 5 6 7 8
SPKR_OUT
- SPKR_OUT+