Sony MDS-W1 - Manual (Page 38)

Editing Recorded MDs
38 EN
5
Press AMS or YES.
A flashing cursor appears in the display.
6
Press A TIME/CHAR or B TIME/CHAR to select
the character type as follows:
To select Press A TIME/CHAR or B TIME/
CHAR repeatedly until
Uppercase letters “A” appears in the display
Lowercase letters “a” appears in the display
Numbers “0” appears in the display
7
Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `
You can press A TIME/CHAR or B TIME/CHAR
to change the character type at any time during
Step 7 (see Step 6).
8
Press AMS to enter the selected character.
The selected character lights continuously and the
cursor flashes waiting for the input of the next
character.
9
Repeat Steps 7 and 8 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press CLEAR.
To enter a space
Press AMS while the cursor is flashing.
10
Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/NO or p.
Note
You cannot label a track or an MD while you are recording
over an existing track.