Sony XL-HF200P(BK) - Manual (Page 6)

E-5
Muting
■
The volume is muted temporarily when pressing the MUTE button on the
remote control. Press again to restore the volume.
X-Bass control
■
When the power is fi rst turned on, the unit will enter the extra bass mode
which emphasizes the bass frequencies, and “X-BASS” will appear. To cancel
the extra bass mode, press the X-BASS button on the remote control.
Bass control
■
Press the BASS/TREBLE button to select “BASS”.
Within 5 seconds, press the VOLUME (+ or -) button to adjust the bass.
1
2
Treble control
■
Press the BASS/TREBLE button to select “TREBLE”.
Within 5 seconds, press the VOLUME (+ or -) button to adjust the treble.
1
2
Equalizer
■
When the EQUALIZER MODE
button is pressed, the current
mode setting will be displayed. To
change to a different mode, press
the EQUALIZER MODE button
repeatedly until the desired
sound mode appears.
Pops
Vocal
Jazz
Flat
Game
Classic
Equalizer off.
For game.
For classical music.
For pop music.
Vocals are enhanced.
For jazz.
Function
■
When the FUNCTION button on main unit is pressed, the current function will
change to different mode. Press the FUNCTION button repeatedly to select
desired function.
FM STEREO CD FM MONO AM
Line In Audio In iPod USB
Note:
The backup function will protect the memorized function mode for a few hours
should there be a power failure or the AC power cord becomes disconnected.
Volume auto fade-in
■
If you turn off and on the main unit with the volume set to 27 or higher, the
volume starts at 16 and fades in to the last set level.
Auto power on function ■
When you press any of the following buttons, the unit turns on.
iPod ® / iPhone, CD, USB, AUDIO / LINE (INPUT), TUNER (BAND) on the
remote control: Selected function is activated.
button on the main unit: The unit turns on and playback of the last
function will start (CD, TUNER, USB, iPod, AUDIO IN, LINE IN)
●
●
Volume control
■
Turn the volume knob toward VOL +/- (on main unit) or press VOLUME
+/- (on remote control) to increase or decrease the volume.
Auto power off function ■
The main unit will enter the stand-by mode (when iPod/iPhone is not docked)
after 15 minutes of inactivity during:
iPod/iPhone: No connection.
AUDIO IN / LINE IN: No detection of input signal or very low sound audibility.
TUNER: No reception of broadcast signal.
CD / USB: In the stop mode.
Note:
However, if iPod/iPhone is docked, the unit will begin charging.
“Charge Mode” will be displayed.
General control
To turn the power on
■
The fi rst time the unit is plugged in, the unit will enter the demonstration mode.
Function Main unit
Remote
control
Operation
Power on/ off Press to turn the
power on or to go to
stand-by mode.
Demo on/ off
____
Press to enter to
demonstration on or
off mode.
Display brightness control ■
To dim the display brightness, press the DEMO/DIMMER button on the
remote control.
Dimmer 1
Dimmer 2
Dimmer off
(Display is dim).
(Display gets dimmer).
(Display is bright).
Volume illuminator
■
When the power is turned on, volume illuminator lights up.
To turn on/off the light, hold down the DEMO/DIMMER button on the
remote control for more than 2 seconds.
●
●
Remote control
Battery installation ■
Use 2 “AAA” size batteries (UM/SUM-4, R3, HP-16 or similar).
Batteries are not included.
Plastic fi lm covering can be removed or peeled off.
Open the battery cover.
Insert the batteries according to the direction indicated in the battery
compartment.
When inserting or removing the batteries, push them toward the
battery terminals.
Close the battery cover. 1
2
3
Caution:
Replace all old batteries with new ones at the same time. Do not mix old
and new batteries.
Do not mix old and new batteries.
Remove the batteries if the unit will not be used for a long period of time.
This will prevent potential damage due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Installing the batteries incorrectly may cause the unit to malfunction.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fi re or the like.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 “AAA” size batteries (UM/SUM-4,
R3, HP-16 or similar).
Periodically clean the transmitter on the remote control and the sensor
on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
Keep the remote control away from moisture, heat, shock, and
vibrations.
●
●
●
●
●
●
●
●
●
●
XL-HF200P_USA_EN.indd 5 XL-HF200P_USA_EN.indd 5 7/16/2010 9:11:00 AM 7/16/2010 9:11:00 AM