Sony BRAVIA KS-60R200A - Manual (Page 32)

32 GB
Manual Program
Preset Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”, press PROG +/- to select
the program number with the channel. You cannot select a program number that is
set to skip.
Program / TV System
Presets program channels manually.
1
Press
F
/
f
to select “Program”, then press .
2 Press
F
/
f
to select the program number you want to manually tune (if
tuning a VCR, select channel 00), then press .
3 Press
F
/
f
to select “TV System”, then press .
4 Press
F
/
f
to select the best received TV broadcast systems, then press
.
5 Press
F
/
f
to select “VHF Low”, “VHF High” or “UHF”, then press .
6 Press
G
/
g
until the desired channel’s broadcast appears on the TV
screen, then press .
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
This name will be displayed briefly on the screen when the channel is selected.
To input characters, follow steps 2 to 4 of “Program Labels” (page 31).
AFT
Allows you to fine-tune the selected program number manually if you feel that a
slight tuning adjustment will improve the picture quality.
You can adjust the fine tuning over a range of -15 to +15. When “On” is selected, the
fine tuning is performed automatically.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or
intermittent sound muting when watching mono programs.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
Note
You cannot receive stereo or dual sound when “Low” or “High” is selected. Normally noise
can be reduced with “Low”. If you still feel the sound is noisy, set the filter to “High”.
Skip
Skips unused channels when you press PROG +/- to select channels. (You can still
select a skipped channel using the number buttons.)
Sensitivity
Adjusts the TV reception sensitivity if the TV signal is too strong and the picture is
distorted. Press
f to select “Low”, then press .
Color System
Selects the color system (“Auto”, “PAL”, “SECAM”, “NTSC3.58”, or
“NTSC4.43”) according to the channel.