Sierra Wireless AIRLINK MP595W - Manual (Page 22)

AirLink MP595 / MP595W Modem User Guide
22 2130795
Required equipment
Package contents
Each MP modem box contains:
• The MP modem
• A mounting template
• Mounting screws and washers
• An installation and documentation CD
• A power harness
If any of these are missing, please contact your account
manager.
Additional required equipment
To install the MP modem, you need the power harness (or
existing MP 555 Series power harness), or an AC/DC adapter
(for office installations), mounting template, and the screws
and washers that come with the device.
You may also require:
• A USB, Ethernet, or 9‐pin serial cable. This must be long
enough to run from the mounting location of the MP
modem to the computer.
· The maximum length for the serial or USB cable is 5.5 m
(18 feet). The USB cable must have a Type A male
connector at the computer end and a Type B male
connector at the MP modem end.
· The Ethernet cable should have RJ‐45 connectors. The
MP modem’s performance is affected by the type of
Ethernet card in the computer and the type of cable
used. The minimum requirement for the Ethernet cable
is an unshielded twisted pair (UTP) cable, category 3 or
4. For better performance, use a shielded, category 5
cable. The maximum length is 100 m (328 feet).
Note: If GPS is being imple-
mented, you require either two
antennas or a combination Main
RF and GPS antenna. • Main Radio frequency antenna and cable. The antenna
must have the appropriate regulatory approval, 50 ohm
impedance, and a male TNC connector. It may be a hard or
magnetic‐mount antenna.
• Access Point antenna and cable. MP 595
• Additional Diversity RF antenna (optional). This is
required if you use the receive diversity feature. The
additional antenna must have a male SMA connector.
• GPS antenna and cable (optional). This is necessary if you
use the built‐in GPS module.
• Power supply. This is usually the vehicle’s battery.