Assembly instructions – Stamina Products 55-2010 User Manual

Page 9

Text mode
Original mode

ASSEMBLY INSTRUCTIONS

SLIDER

CABLE END

PLASTIC FITTING

PLASTIC BRACKET

STEP 7

Set the

TENSION KNOB(27)

at position

"8".

Connect the

CABLE END

of the

TENSION KNOB(27)

into the

SLIDER

in the

PLASTIC BRACKET.

Pull on the

TENSION KNOB(27)

firmly so that enough

cable is available to insert the cable through the slot in the top of the

PLASTIC BRACKET.

Then insert

the plastic fitting on the

TENSION KNOB(27)

into the hole in the

PLASTIC BRACKET.

Install the

TENSION KNOB(27)

into the square hole on the

UPRIGHT(4)

and secure with

SCREW(M5 x 30mm)

(92)

and

WASHER(M5)(93).

STEP 8

There is a

"L"

mark on the

LEFT PEDAL CAP(41),

and a

"R"

mark on the

RIGHT PEDAL CAP(42).

Attach the

RIGHT

PEDAL CAP(42)

to the

RIGHT PEDAL SLIDER(48)

with

BUTTON HEAD BOLTS

(M8 x 20mm)(90).

Repeat on the left side.