Sharp PG-M20X - Manual (Page 59)

Easy to Use Functions
-55
Setting the Video Signal
Setting the Video
Signal
Select “Video System” in the “Options
(1)” menu
➝ For settings, see page
38 .
Note
• The video signal can only be set in IN-
PUT 2 or INPUT 3 mode.
• In “Auto”, images are displayed in PAL
even if PAL-N or PAL-M input signals are
received.
When connected to PAL video equipment.
When connected to SECAM video
equipment.
When reproducing NTSC signals in
PAL video equipment.
When connected to NTSC video equipment. PAL
SECAM
NTSC4.43
NTSC3.58
The video input system mode is preset to “Auto”; however, a clear picture from the con-
nected audio-visual equipment may not be received, depending on the video signal differ-
ence. In that case, switch the video signal.