Sharp PG-M20X - Manual (Page 55)

Easy to Use Functions
-51
Displaying Dual Pictures ( Pict in Pict )
Picture in Picture function allows you to display two pictures on the same screen. You can
display the image input from INPUT 2 or 3 as an inset picture overlapping the main picture
from INPUT 1. (This function can only be set in the RGB menu.)
Displaying the Inset Picture
Select “Pict in Pict” in the “Options (1)”
menu
➝ For displaying, see page
36 .
1
Press to select .
• Select
to clear the Pict in Pict mode.
2
Press or on the remote
control or on the projector
to switch the image in the inset
picture.
3
Press , , or to set
the position of the inset picture.
• Press to stop the frame from mov-
ing or to make the frame disappear.
4
Press to move the inset pic-
ture.
• The inset picture will be moved to the
inset picture frame.
Note
• The inset picture can only be displayed
with composite video (NTSC/PAL/
SECAM) or S-Video signal.
• The Freeze function works only with the
inset picture, when the Pict in Pict mode
is in operation.
When the signal entered into INPUT 1 is
as follows, Pict in Pict does not work:
• With a resolution that overexceeds
SXGA.
• When the input signal is 480 I , 480P,
720P or 1080 I .
• When the input signal has changed to
the Interlace mode using RGB signals.
• When the picture display mode is set to
“DOT BY DOT”.
• When no signals are sent to INPUT 1,
or when the resolution or refresh rate
(vertical frequency) is changed.
• Press or on the remote control or
on the projector to switch the image
in the inset picture.