Sony R-DG1200 - Manual (Page 40)

40 US
D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm masterpage: Left
STR-DG1200
3-289-135-11(1)
4
Press V/v repeatedly to select
“Impedance”, then press .
5
Press V/v repeatedly to select
“4
Ω” or “8 Ω” depending on
the speakers you are using,
then press
.
Notes
• If you are not sure of the impedances of the
speakers, refer to the operating instructions
supplied with your speakers. (This information is
often found on the back of the speaker.)
• When you connect all speakers with a normal
impedance of 8 ohms or higher, set “Impedance” to
“8
Ω”. When connecting other types of speakers,
set it to “4 Ω”.
• When you connect front speakers to both the
SPEAKERS A and B terminals, connect the
speakers with a normal impedance of 8 ohms or
higher.
– When you connect speakers with impedance of
16 ohms or higher in both “A” and “B”
configuration:
Set “Impedance” to “8
Ω” in the Speaker
settings menu.
– For other types of speakers in other
configurations:
Set “Impedance” to “4
Ω” in the Speaker
settings menu.
You can select the front speakers you want to
drive.
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
Note
This setting is not available when headphones are
connected.
To turn off the speaker output
Press SPEAKERS (OFF/A/B/A+B)
repeatedly until the “SP A”, “SP B” and “SP
A+B” indicators in the display window light
off.
“ALL OFF” appears in the display window.
Selecting the front speakers
To select Light up
The speakers connected to the
FRONT SPEAKERS A terminals. SP A
The speakers connected to the
FRONT SPEAKERS B terminals. SP B
The speakers connected to both the
FRONT SPEAKERS A and B
terminals (parallel connection). SP A+B
SPEAKERS (OFF/A/B/A+B)