Sharp AR-151 - Manual (Page 30)

28
5
Copier trouble?
MISFEED REMOVAL
Gently remove the misfed paper from under the fusing unit as shown in the illustration.
If the paper cannot be removed, proceed to “C Misfeed in the transport area”.
The fusing unit is hot. Do not touch the fusing unit when removing misfed
paper. Doing so may cause a burn or other injury.
● Do not touch the photoconductive drum (green portion) when removing the
misfed paper. Doing so may damage the drum and cause smudges on copies.
● Do not remove the misfed paper from above the fusing unit. Unfixed toner on
the paper may stain the paper transport area, resulting in smudges on copies.
Raise the fusing unit release lever and then close the side cover by pressing the
round projections near the side cover open button. The misfeed (
) indicator will go
out and the ready ( ) indicator will light up.
C Misfeed in the transport area
Lower the fusing unit release lever by rotating it all the way as shown in the illustration.
While you are lowering the fusing unit release lever, it will not move smoothly
at a location on the way. However, be sure to lower the lever by rotating it all
the way to the location where it will not rotate as shown in the right illustration.
Fusing unit release lever