Sanyo CA21XS2S - Manual (Page 8)

8
General Operation
■ ■ If no operation is performed after the TV has
been switched on by the ON TIMER, such as if
you are not at home, the TV will be
automatically switched off after approximately
2 hours
■ ■ If the TV is already switched on when the time
set for the ON TIMER has been reached, only
the programme position will be changed to the
set programme position.
■ ■ Cancelling ON TIMER. To cancel the ON
TIMER, press the VOLUME ( + or - ) button to
set it to “ON 0:00” while the ON TIMER screen is
shown. Switching off the TV by pressing the
Mains ON/OFF button will also cancel the ON
TIMER settings.
The OFF TIMER will switch off the TV automatical-
ly after 30 minutes, 1 hour, 1 hour and 30 minutes,
or 2 hours.
■ Just one minute before switching off the TV,
“OFF 0:01” will be display on the screen.
■ To cancel the OFF TIMER, select “OFF 0:00”
by pressing the VOLUME (+ or - ) button.
■ The OFF TIMER cancels when the TV set is
turned off or if a power failure occurs.
When the ON TIMER is set. TV will automatically
be switched On to the selected programme position
when the specified time has elapsed.
Programme position for when TV is
switched ON by ON TIMER.
❒ Off Timer
1
Press the TIMER button.
OFF 0:00
2
Press the VOLUME ( + or - ) button to select
the time period.
❒ On Timer
1
Press the TIMER button twice.
ON 0:00 2
(ON TIMER setting mode)
2
Press the VOLUME ( + or - ) button. The set
time will be increased or decreased by 10
minutes each time the button is pressed ; the
maximum time which can be set is 24 hours.
3
Use Direct Programme Selection to insert
programme position for when TV is switched
on by ON TIMER. (see page 7.)
❒ On Timer (Continued)
Normally, set the colour system to “AUTO”, if the
clear picture cannot be obtained even when the
broadcasting or AV signal is received, press the
RECALL/COLOUR SYSTEM button repeatedly
until the optimum image can be produced.
(Refer to Broadcast Transmission System List
indicated by the last of this page in a setup of
Colour System.)
Each time the RECALL/COLOUR SYSTEM but-
ton is pressed, colour system changes as follows;
To set the sound system, make it during Semi-Auto
Tuning or Manual Tuning mode.
When the sound is not clear or no sound is pro-
duced on a programme number position, select
sound system repeatedly until the optimum sound
is obtained.
(Refer to Broadcast Transmission System List
indicated by the last of this page in a setup of
Sound System.)
To select sound system:
■ Press the SOUND SYSTEM button to select the
sound system directly. The sound system will be
memorized automatically.
Note:Colour system is displayed according as
Colour system option.
6
AUTO
6
PAL
6
NTSC
6
NTSC4.43
Colour and Sound System
❒ Setting of the Colour System
❒ Setting of the Sound System
or:
1) Select “SIF” with the Programme UP or
DOWN button in the Semi-auto or Manual
Tuning mode. Then press the VOLUME (+ or
-) button to select a optimum sound system.
INST. MANUAL-BE4D-A (AUS) 4/1/08 5:37 PM Page 8