Sanyo MBR-704G - Manual (Page 20)

19
ROUTINE MAINTENANCE
Replacement of fluorescent lamp
The fluorescent lamp is placed horizontally in the upper front of the chamber. Follow the procedure
below to replace the lamp.
1. Turn off the fluorescent light switch and disconnect
the power supply plug.
2. Hold the cover of the light and pull downward with
lead wire to remove the lamp from stopper. (Fig. 1)
3. Remove the water-proof rubber on the left. (Fig. 2)
4. Remove the socket on the left. (Fig. 2)
5. Take out the fluorescent lamp gently from the
protective cover.
6. After placing a new fluorescent lamp in the protective
cover, replace the socket and then replace the
water-proof rubber.
7. Fix the light with the stoppers.
Replacement of glow starter
A glow starter is located inside the front cover.
1. Disconnect the power supply plug.
2. Remove the water-proof rubber.
3. Remove the glow starter and replace with a new one.
4. Replace the water-proof rubber.
DISPOSAL OF UNIT
WARNING
If the unit is to be stored unused in an unsupervised area for an extended period ensure that children
do not have access and doors cannot be closed completely.
The disposal of the unit should be accomplished by appropriate personnel. Always remove
doors to prevent accidents such as suffocation.
This product has an electric battery.
Please recycle it for effective utilization of resources and protection of our environment.
Thank you for your cooperation.
Label indication is obliged to comply with Taiwanese battery regulation.
Fig. 1
Fig. 2
Water-proof rubber
Socket
Water-proof rubber
Socket