Samsung Refrigerator User Manual

Page 22

Removing any residual matter inside the water supply line after installing
filter.

1. Turn ON the main water supply & turn OFF the valve to the

water supply line.

2. Run water through the dispenser until the water runs clear

(approx. 1L). This will clean the water supply system and remove
air from the lines.

3. Additional flushing may be required in some households.
4. Open the refrigerator door and make sure there are no water

leaks coming from the water filter.

A newly installed water filter cartridge may cause water to
briefly spurt from the water dispenser. This is due to air getting
into the line. It should pose no problem to operation.

Check the amount of water supplied to the ice tray. (Optional)

1. Lift up the icemaker bucket and gently pull out of the freezer.
2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the

water supply tap after ice tray is twisted. Check to make sure the amount of water is correct(see
the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem from

with in the main water pipes, not the refrigerator.

ice maker

feeler arm

test button

Check the water level

setting up

DA99-01583A(HM)-EN(0.0).indd 22

2007.8.23 4:25:45 PM