Setting up your side-by-side refrigerator – Samsung Refrigerator User Manual

Page 19

CAUTION

01
s

tting

setting up your side-by-side

refrigerator

Connecting the water line to the refrigerator

1. Remove the cap from water line on the unit and insert compression nut to the water line on the unit

after disassembling from provided water line.

2. Connect both water line from the unit and water line provided kit.
3. Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4. Turn water on and check for any leakage.

Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.

Before being used, the leakage in these places should be examined

• Samsung Warranty does not cover

WATER LINE INSTALLATION.

• It’ll be done at customer’s charge

except the retail price includes
installation cost.

• Please contact Plumber or Authorized

Installer for the installation if needed.

• If Water leakage happened due to improper installation, Please contact installer.

Remove

cap

Water Line

from unit

Water Line

from Kit

No gap

Loosen a

Installing the water filter.

1. Remove the water filter from the box and put a replacement

indicator sticker on the filter as shown.

2. Place a sticker on the filter that dates six months in the

future. For example, if you install the water filter in March,
put the “SEP” sticker on the filter to remind you to replace in
September. That way you’ll know when it is time to replace
the filter. Normally filter life is about 6 months.

3. Next, remove the fixed cap by turning it counter clockwise.

Keep the cap in a safe place for use if you choose not to use a
filter.

4. Remove the filter’s protective cap and then

position and insert the filter into the filter housing.

5. Slowly turn the water filter clockwise 90º to align

with the indication mark on the cover, locking the
filter in position. Make sure that the indicator is
lined up with the “lock” position. Remember, do
not over-tighten.

If your model contains wine shelf, you should
remove the wine shelf before installing water
filters.

setting up

sticker

(Month indication)

Cover filter

align the indication

mark with lock position

separation

of red cap

DA99-01583A(HM)-EN(0.0).indd 19

2007.8.23 4:25:40 PM