Samsung Refrigerator - Manual (Page 18)

1_ setting up
3. After adjusting the doors, turn the nut 1 clockwise until it reaches the lower end of the
bolt, then tighten the bolt again with the wrench to fix the nut in place 1 .
If you do not secure the nut firmly, the bolt may release.
Close Main
Water pipe
Close Main
Water pipe
NO GAp
1
Wrench
Bolt
Nut
CHECKing tHE watEr DisPEnsEr LinE (oPtionaL)
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better
health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize
or destroy microorganisms. You will need to purchase a water purifying system to do that. In order for the
icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc
paper cup can be filled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below
138 Kpa), you can install a booster pump to compensate for the low pressure. Make sure the water storage
tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from
the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer drawer.
instaLLing tHE watEr DisPEnsEr LinE
For Interior model
Parts for water line Installation
1
Water line fixer
and screws
pipe
connector
Water Line
protection tube Water line Water Filter
Connecting to the water supply line
1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.
CAUTION
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
4. After connecting the water supply to the water filter, turn your main water supply back on and
dispense about 1l to clear and prime the water filter.
DA99-01583A(HM)-EN(0.0).indd 18 2007.8.23 4:25:37 PM