Spirit Z500 - Manual (Page 4)

DANGER - To reduce the risk of electric shock disconnect your elliptical from the electrical
outlet prior to cleaning and/or service work.
WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons, install the
elliptical on a flat level surface with access to a nominal 110-volt, 15-amp grounded outlet
with only the elliptical plugged into the circuit..
DO NOT USE AN EXTENSION CORD UNLESS IT IS A 14AWG OR BETTER, WITH ONLY
ONE OUTLET ON THE END: DO NOT ATTEMPT TO DISABLE THE GROUNDED PLUG BY
USING IMPROPER ADAPTERS, OR IN ANY WAY MODIFY THE CORD SET. A serious
shock or fire hazard may result along with computer malfunctions. See Grounding
Instructions, page 4.
■ Do not operate
elliptical on deeply padded, plush or shag carpet. Damage to both
the carpet and elliptical may result.
■ Keep children away from the
elliptical . There are obvious pinch points, moving parts
and other caution areas that can cause harm.
■ Keep hands away from all moving parts.
■ Never operate the elliptical if it has a damaged cord or plug. If the elliptical is not working
properly, call your dealer.
■ Keep the cord away from heated surfaces.
■ Do not operate where aerosol spray products are being used or where oxygen is
being administered. Sparks from the motor could ignite a highly gaseous environment
■ Never drop or insert any object into any openings.
■ Do not use outdoors.
■ To disconnect, turn all controls to the off position, then remove the plug from the outlet.
■ Do not attempt to use your
elliptical for any purpose other than for the purpose it is
intended.
■ The hand pulse sensors are not medical devices. Various factors, including the user’s
movement, may affect the accuracy of heart rate readings. The pulse sensors are
intended only as exercise aids in determining heart rate trends in general.
■ Wear proper shoes. High heels, dress shoes, sandals or bare feet are not suitable
for use on your elliptical . Quality athletic shoes are recommended to avoid leg fatigue.
Important Safety Instructions
Important Electrical Information
WARNING!
● NEVER remove any cover without first disconnecting AC power supply.
● If A.C. voltage varies by ten percent (10%) or more, the performance of your elliptical may be
affected. Such conditions are not covered under your warranty. If you suspect the voltage is
low, contact your local power company or a licensed electrician for proper testing.
● NEVER expose this elliptical to rain or moisture. This product is NOT designed for
Use outdoors, near a pool or spa, or in any other high humidity environment. The operating
temperature specification is 40 to 120 degrees Fahrenheit and humidity limit is 95%,
non-condensing (no water drops forming on surfaces).
EL7 Elliptical
3