Spirit Z500 - Manual (Page 13)

EL7 Elliptical
12
STEP 4: PLASTICS ASSEMBLY
1. Match up the Connecting Arm Covers (71 and 72) and install onto the Left and Right
Connecting Arms (8&9) and secure each side with two M5x15mm Phillips Head Screws
(82) and one 3.5x12mm Sheet Metal Screws (107) by using Short Phillips Head Screw
Driver (125).
2. Install Sliding Wheel Covers (64) on each side and secure with four M5x15mm Phillips
Head Screws (82).
3. Install the two Stabilizer Covers (60 and 61) on the middle stabilizer bar with two
M5x15mm Phillips Head Screws (82).
4. Install the Front Stabilizer Cover (59) on the front stabilizer with two M5x15mm Phillips
Head Screws (82).
5. Install the two incline Cover brackets (156), with the hole for mounting the plastic cover
on the bent tab facing rearward, and secure them on the Incline Rail Assembly (2) with
four M6x10mm Phillips Head Screws (157). Install the Rear incline bar cover (73-2) on
the rail base with two M5 x 15m/m Screws (82).
6. Install the Rear Stabilizer Cover (73-3) on the Rear Stabilizer with four M5x15mm
Phillips Head Screws (82).
7. *This step to be performed after the elliptical power is plugged in. Run the incline to
position 8 and install the incline Rail front cover (73) up against the middle stabilizer tube
with four M5x15mm Phillips Head Screws (82).
PLEASE ENSURE ALL THE FASTENERS ARE TIGHT AFTER ALL THE ASSEMBLY
STEPS HAVE BEEN COMPLETED.