Spirit Z500 User Manual
Page 12
STEP 3: CONNECTING ARM ASSEMBLY
Untie the wire holding the Sleeve Spacer (22) in place on the rod-end bearings located on the
ends of the connecting arms (8&9). Align the hole in the rod ends with the hole in the brackets of
the left and right Handle Bar (10&11). The rod end should be on the inside of the Handle Bar
bracket. Secure both sides with a 5/16”x1-1/4” Hex Head Bolt (79), 5/16”x20mm Flat Washer (100)
and 5/16” Nylon Nut (91) by using 13/14 mm Wrench (124) and 12/14 mm Wrench (129).
EL7 Elliptical
11
This manual is related to the following products:
See also other documents in the category Spirit Sports and recreation:
- Esprit ET2 (28 pages)
- XT200 (12 pages)
- ZE501 (14 pages)
- Z700 (7 pages)
- XU875 (35 pages)
- EL1 (22 pages)
- Z8 (1 page)
- XT 800 (15 pages)
- ZE20 (15 pages)
- Z300 (22 pages)
- CR800 (35 pages)
- XT685 (38 pages)
- XT2751 (28 pages)
- CT 800 (25 pages)
- XE 125 (16 pages)
- XE 100 (45 pages)
- XT4851 (29 pages)
- XT385 (32 pages)
- XG400 (28 pages)
- Esprit ET10 (27 pages)
- Z900 (24 pages)
- XT101 (27 pages)
- XT375 (33 pages)
- XE150 (35 pages)
- IN300T (18 pages)
- XE395 (32 pages)
- XT600 (39 pages)
- EL 5 Elliptical (39 pages)
- XT485 (35 pages)
- XE700 (31 pages)
- XT285 (29 pages)
- 7300 (12 pages)
- XBR25 (34 pages)
- ZE40 (17 pages)
- XBR55 (30 pages)
- XE400 (29 pages)
- XT185 (27 pages)
- xt9 (19 pages)
- IN839 (16 pages)
- XE 850 (29 pages)
- XE295 (30 pages)
- XT475 (33 pages)
- EL255 (20 pages)