Spirit Z500 - Manual (Page 11)

STEP 2: HANDLE BAR ASSEMBLY
1. Install the two 25m/m Wave Washers (102) onto the Left and Right side of the Handle Bar axle.
2. Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The
handlebars have a small sticker on them indicating L (left) and R (right).
3. Install two 3/8” X 35 mm Flat Washers (131) onto the two 3/8” X 3/4” Hex Head Bolts (76) and
install, and tighten, in the threaded holes in the ends of the axle.
4. Install the Front Handle Bar Covers (68 left, 69 right) and Rear Handle Bar Covers (68-1 left,
69-1 right) over the Handle Bar axle connections and secure with the six 3.5x10m/m Sheet
Metal Screws (107).
EL7 Elliptical
10