Sanyo CAS-D6325 - Manual (Page 10)

E8
GETTING
STARTED
Connecting the Base and Charging the Handset
Connect the yellow-tipped AC adapter cord to the DC IN 9V jack.
Connect the AC adapter to a standard 120V AC wall outlet. DO
NOT use an AC outlet controlled by a wall switch.
Place the handset in the base with the LCD screen facing
forward.
Make sure that the CHARGE LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and
the handset makes good contact with the charging contacts.
Charge your handset at least 15 to 20 hours before plugging
into the phone line.
Notes:
Connect the AC adapter to a continuous power supply.
Place the base unit close to the AC outlet so that you can plug the AC adapter easily.
It is normal for the handset and base to get warm, when the handset is charging in the base unit. •
•
•
IMPORTANT
Use only the supplied SANYO AC adapter. Do not use any other AC adapter.
Do not place the power cord so that it creates a trip hazard or where it could become damaged and create a fire or electrical hazard. •
•
1.
2.
3.
4.
5.
To AC outlet
AC adapter
(supplied)
To DC IN 9V
Route the cord.
To AC outlet
AC adapter
(supplied)
To DC IN 9V
Route the cord.
UC590EH.indd E8 UC590EH.indd E8 8/19/2008 11:38:58 AM 8/19/2008 11:38:58 AM